There was need for an antenna for our SatNogs (Satellite Ground Station Network). As serious hackers there was no other option than to build one of our own. After several more or less unsuccessful experiments with several antenna types we decided to build a Lindenblad antenna for the 2 meters (144 Mhz frequency) range. We are Ronny (DL7ROX) and myself (DM1AS). There are several papers and discussions available on how to build such an antenna, most of them vom Amsat and US in general.
The cross connection in between the 4 dipoles is the same aluminium tube with a length of 584 mm.
As we have 4 dipoles of 50 Ohm impedance in parallel and the wire typically as 50 Ohm we need to match it. The solution in the paper is to use an 75 Ohm TV wire with a defined range so it will match the 200 Ohm to the 50 Ohm of the wire impedance.
Put it all together
Each dipol will be connected to one impedance matching wire and all 4 wires to the antenna wire. Don’t forget a cable ferrite on each of the impedance matching wires very close to the dipol side. The 4 dipoles will then be connected opposite to each other and each dipole rotated by 30 degrees clockwise to the horizon.
Measure the SWR
We measured the dimensions with an AA-1400 and where very proud to get such a great result of 1 at the center frequency.
Wolfgang Kaufmann wrote an impressive article and even a more impressive software for the hobby radio astronomers. I highly recommend checking out the article and play with the software as there are not so many radio astronomers among the community. His software is written in python with a very clean UI. It directly connects via the computer sound card and grabs the audio signal. I shortly describe here what to install on a Mac OS to get his software up and running.
I recently bought myself a SDRPlay receiver to play with this technology and maybe build a ground station or meteor scatter detector. The original plan is to setup a receiver on the Motionlab roof with an raspberry pi and send the IQ data via network down to a local server and extract the interesting information. One great software to work remotely with an SDR receiver is the Soapy project.